Technical Data:

Drying channel width: 2000mm or as required
Conveyor width:1800mm or as required
Drying lane length:15400mm
Conveying speed:0-8m/min
Temperature adjustment range: room temperature to 180℃
Drying temperature: 45℃
High efficiency infrared medium wave tube: 4.5KW/pc
Motor power: 1.5KW
Total power: 98KW
Air consumption: 6kg/c㎡
Machine size: 14000×2400×1500mm

Auto glass windshield ink dryer is the supporting equipment of automatic production line, mainly used for drying and cooling after the printing of auto and bus glass. This machine is composed of two major parts: the drying area and the air-cooling area. The transmission speed adopts a high-quality frequency converter with step-less variable speed, and the drying temperature can be set arbitrarily between normal temperature and 180℃.

Features of auto glass ink drying machine:

The material of the main machine adopts the standard profile welding combination, the heating part of the upper part of the lamp reflection cover and the inner liner part is made of stainless steel.

The conveying adopts the brand reducer motor to transmit to the conveying stick shaft to drive the Teflon circle to convey the glass piece, the conveying speed is steplessly changed by frequency converter so that the glass is conveyed without scratching under high temperature.

Adopt high efficient direct injection hot air convection circulation system.

The hot air section is equipped with an upper exhaust motor to keep the air inside the furnace fresh.

The auto glass ink drying machine is divided into two parts:

Hot air zone:

The hot air area is divided into three groups, each group of hot air selection of six infrared amplitude in the wave tube heating, while the spare three installation positions to facilitate future upgrades, the upper part of the high-temperature fan to recover the heat inside the drying channel for hot air circulation, that is, to make the drying channel internal balanced heating and can make full use of thermal efficiency, hot air circulation flow. The temperature control adopts a digital display temperature automatic controller, (SCR silicon control rectifier, constant temperature control) three groups of heating area temperatures can be individually controlled and set, each group of heating areas is equipped with a waste discharge port.

Strong wind:

The strong wind cooling area is divided into two groups, each group can be independent, easy to operate. Using the ambient air, through the upper hood concave slot wind mouth to form wind pressure blowing wind, to achieve the purpose of glass cooling, exhaust gas natural emissions, purify the working environment.

The built-in cylinder lifting system can lift the oven to inspect the interior, which is convenient for maintenance.

The baking tunnel adopts high-grade aluminum silicate fiber heat insulation board to improve the thermal efficiency and optimize the working environment.